Introduction
All bulb specifications are listed on page 311. The following bulbs should only be replaced by a trained and qualified Volvo service technician:
- Dome lighting
- Reading lights
- Glove compartment lighting
- Footwell lighting
- Turn signals in the door mirrors
- Approach lighting in the door mirrors
- Active Bending Lights and LED bulbs
See page 311 for a list of bulb specifications.
NOTE
For information regarding any other bulbs not mentioned in this section, please contact your Volvo retailer or a trained and authorized Volvo service technician.
WARNING
- The engine should not be running when changing bulbs.
- If the engine has been running just prior to replacing bulbs in the headlight housing, please keep in mind that components in the engine compartment will be hot.
WARNING
- Active Bending Lights* – due to the high voltage used by these headlights, these bulbs should only be replaced by a trained and qualified Volvo service technician.
- Turn off the lights and remove the remote key from the ignition before changing any bulbs.
See also:
Voice control support features
• Tutorial: A feature that helps acquaint you
with the system and the procedure for giving
commands.
• Training: A feature that enables the voice
control system to become familiar with
your v ...
Ignition modes and electrical current to RSE
RSE can be activated with the ignition in
modes I or II (and when the engine is running).
See page 82 for detailed information about the
various ignition modes. If a film is being played,
it wi ...
Fault tracing and actions
If the message Radar blocked See manual is displayed, this means that the radar
signals from the sensor have been obstructed and that a vehicle ahead cannot be
detected.
This, in turn, means that ...