License plate lighting
1. Remove the screws with a screwdriver.
2. Carefully detach the entire bulb housing and pull it out.
3. Replace the bulb.
4. Reinsert the entire bulb housing and tighten the screws.
See also:
Power windows
The power windows are controlled by buttons
in the arm rests. The ignition switch must be
ON1 (ignition key in position I, II or the engine
running) for the electrically operated windows
to functi ...
Service position
Wiper blades in service position
The wiper blades must be in the vertical (service) position for replacement,
washing or to lift them away from the windshield when e.g., removing ice or snow.
T ...
Components in the SIPS airbag system
This SIPS airbag system consists of a gas generator, the side airbag modules
built into the outboard sides of both front seat backrests, and electronic sensors/wiring.
WARNING
The SIPS air ...