Low beam, Halogen
1. Remove the headlight housing from the vehicle (see page 306).
2. Remove the cover over the bulbs (see page 308).
3. Unplug the connector from the bulb.
4. Remove the bulb by pulling it straight out.
5. The guide lug on the new bulb should be straight up when the bulb is inserted into the holder and the bulb should snap into place.
6. Put the cover back into position and reinstall the headlight housing.
See also:
Removing the ball holder
1. Remove the cotter pin from the locking bolt
and slide the locking bolt out of the ball
holder/hitch assembly.
2. Pull the ball holder out of the hitch assembly.
NOTE
A cover for the hitch as ...
Introduction
The HomeLink1 Wireless Control System provides a convenient way to replace up
to three hand-held radio-frequency (RF) transmitters used to activate devices such
as gate operators, garage door op ...
Rear park assist
The distance monitored behind the vehicle is approximately 5 ft (1.5 m). The
audible signal comes from the rear speakers.
The system must be deactivated when towing a trailer, carrying bicycles i ...