Changing wheels

Location of the jack
The jack is located in the center under the rear hatch in the cargo area floor. Lift this hatch and release the retaining strap to slide out the jack.
The rear section of the jack's crank and the tool bag are stowed in the foam block. The front (hook) section of the crank is stored in the tool bag.
The rear section of the crank is stored in the foam block.
If the vehicle is equipped with the optional grocery bag holder: Fold up the rear section of the cargo area floor, disconnect the grocery bag holder's retaining cords and fold up the lower section of the floor.
NOTE
The rear section of the crank is enclosed in
a protective sleeve that should be slid off
before the crank is used. We recommend
reinserting the crank into this sleeve before
the crank is stowed.
CAUTION
Seven-seat models: Do not store objects
in the area for the rear seat cushions (when
the backrests are to be folded down). This
could damage the cushions.
See also:
Attaching the towing eyelet
The towing eyelet is located under the floor of the trunk. This eyelet must
be screwed into the positions provided on the right sides of either the front
or rear bumper (see illustration).
...
Locking
1. Switch off the engine (see page 114 for
details).
2. Remove the remote key from the ignition
slot.
3. Open the driver's door.
> A sound will be audible when the steering
wheel lock enga ...
Driving distance on current fuel reserve
This function shows the approximate distance
that can be driven on the fuel remaining in the
tank. The calculation is based on average fuel
consumption during the last 20 miles (30 km)
of driv ...
