Operation
Controls and display
1 Resume previous settings, increase speed (each additional press increases
speed by 1 mph (approximately 2 km/h).
2 Standby mode on/off
3 Set time interval
4 Put in active mode and set a speed
5 Set speed (parentheses indicate standby mode)
6 Time interval while it is being set
7 Time interval after it has been set
See also:
Disabling the passenger's side front airbag
Occupant Weight Sensor (OWS) indicator light
Volvo recommends that ALL occupants (adults and children) shorter than 4 feet
7 inches (140 cm) be seated in the back seat of any vehicle with a front ...
Replacing fuses
There are relay/fuse boxes located in the
engine compartment, the passenger compartment,
and the cargo area.
If an electrical component fails to function, this
may be due to a blown fuse. The e ...
Checking and adding oil
Location of the filler cap and dipstick
Volvo recommends Castrol oil products
NOTE
Before checking the oil:
• The car should be parked on a level surface.
• If the engine is warm, wait for at ...