Limitations
In certain situations, the BLIS indicator light(s) may illuminate even when there are no other vehicles in the area monitored by the system.
NOTE
If the BLIS indicator lights illuminate occasionally
even when there are no other vehicles
in the blind area, this does not indicate
a fault in the system.
In the event of a fault, Blind spot syst.
service required will be displayed.
The following are several examples of situations in which the BLIS indicator light(s) may illuminate even when there are no other vehicles in the area monitored by the system.
Light reflected from a wet road surface
The vehicle's own shadow against a large, light, smooth surface such as barriers between lanes on a highway
Sunlight directly in the camera when the sun is low on the horizon
See also:
Unbuckling the seat belt
To remove the seat belt, press the red section
on the seat belt receptacle. Before exiting the
vehicle, check that the seat belt retracts fully
after being unbuckled. If necessary, guide the
b ...
Introduction
Adaptive Cruise Control (ACC) is an optional
system designed to assist the driver by maintaining
a set speed or a set time interval to the
vehicle ahead. It is primarily intended for use
on lo ...
Reporting safety defects in the U.S.
If you believe that your vehicle has a
defect which could cause a crash or
could cause injury or death, you
should immediately inform the
National Highway Traffic Safety
Administration (NHTS ...