Changing



WARNING
Connect and disconnect the positive and negative cables in the correct sequence.
Removal
Switch off the ignition, remove the remote key from the ignition slot and wait at least 5 minutes before disconnecting the battery so that all information in the vehicle's electrical system can be stored in the control modules.
- Open the clips on the front cover and remove the cover.
- Release the rubber molding so that the rear cover is free.
- Remove the rear cover by pulling it away.
-
- Detach the black negative cable.
- Detach the red positive cable
- Detach the ventilation hose from the battery
- Loosen the screw holding the battery clamp.
- Move the battery to the side and lift it up.
WARNING
PROPOSITION 65 WARNING!
Battery posts, terminals, and related accessories contain lead and lead compounds, chemicals known to the state of California to cause cancer and reproductive harm. Wash hands after handling.
See also:
What is an Onboard Diagnostic System (OBD II)?
OBD II is part of your vehicle's computerized
engine management system. It stores diagnostic
information about your vehicle's emission
controls. It can light the Check Engine light
(MIL) if it ...
Spare wheel
The spare wheel is only intended for temporary
use. Replace it with a normal wheel as soon as
possible. The car's handling may be altered by
the use of the spare wheel. The correct tire
pressu ...
Manual locking
In certain situations (e.g., if there is no electrical current in the vehicle),
the doors can be locked manually.
The detachable key blade (see page 59) can be used in the lock cylinder in the
dr ...
