Limitations

In certain situations, the BLIS indicator light(s) may illuminate even when there are no other vehicles in the area monitored by the system.
NOTE
If the BLIS indicator lights illuminate occasionally
even when there are no other vehicles
in the blind area, this does not indicate
a fault in the system.
In the event of a fault, Blind spot syst.
Service required will be displayed.
The following are several examples of situations in which the BLIS indicator light(s) may illuminate even when there are no other vehicles in the area monitored by the system.

Light reflected from a wet road surface

The vehicle's own shadow against a large, light, smooth surface such as
barriers between lanes on a highway

Sunlight directly in the camera when the sun is low on the horizon
See also:
Child safety locks
Child safety locks – rear doors
The controls are located on the rear door
jambs. Use the remote control's key blade or a
screwdriver to adjust these controls.
A The rear doors can only be open ...
Standby mode due to action by the driver
ACC is temporarily deactivated and put in standby mode:
when the brakes are applied
if the driver's seat belt is taken off
If the driver's door is opened
if the gear selector is move ...
Seat belt use during pregnancy
The seat belt should always be worn during
pregnancy. But it is crucial that it be worn in the
correct way. The diagonal section should wrap
over the shoulder then be routed between the
breasts ...
