Settings
Settings for Lane Departure Warning can be
made in the menu system by pressing My
Car. Go to Settings
Car settings
Driver
support systems
Lane Departure
Warning.
There are two alternatives:
On at start-up: This selection switches LDW on each time the engine is started. Otherwise, the system will be in the mode that it was in when the engine was switched off.
Increased sensitivity: This selection increases the function’s sensitivity. Warnings will be given at an earlier stage and fewer limitations apply. When this setting is being used, the system only needs to monitor lane marker lines on one side of the vehicle to change status to Lane Depart Warn Available.
See also:
Automatic re-arming
If the doors are unlocked, the locks will automatically
reengage (re-lock) and the alarm will
re-arm after 2 minutes unless a door or the tailgate
has been opened. ...
Driving through water
The vehicle can be driven through water up to a depth of approximately 10
in. (25 cm), at a maximum speed of 6 mph (10 km/h).
Take particular care when driving through flowing water.
Clean t ...
The camera’s limitations
The camera is used by Collision Warning with
Auto-brake, Driver Alert Control (see
page 180), and Lane Departure Warning (see
page 183).
NOTE
• To help protect the camera in very hot
conditi ...