Introduction

Adaptive Cruise Control (ACC) is an optional system designed to assist the driver by maintaining a set speed or a set time interval to the vehicle ahead. It is primarily intended for use on long straight roads in steady traffic, such as on highways and other main roads.
When the driver has set the desired speed and the time interval to the vehicle ahead, ACC functions as follows:
• If there are no other vehicles in the lane ahead of you, your vehicle will travel at the set speed.
• If ACC's radar sensor detects a slower moving vehicle in the lane ahead, the system will adapt your vehicle's speed to help maintain the set time interval to the vehicle ahead. When there are no longer slower moving vehicles ahead, your vehicle will accelerate to resume the set speed.
If ACC is switched off completely or in standby mode and your vehicle comes too close to another vehicle ahead, the driver will be warned by the Distance Alert system (see page 164).
WARNING
• Adaptive Cruise Control cannot cover
all driving situations and traffic, weather
and road conditions. The "Function"
section provides information about limitations
that the driver must be aware of
before using this feature.
• This system is designed to be a supplementary
driving aid. It is not, however,
intended to replace the driver's attention
and judgement. The driver is
responsible for maintaining a safe distance
and speed and must intervene if
Adaptive Cruise Control does not maintain
a suitable speed or suitable distance
to the vehicle ahead.
• Maintenance of ACC components may
only be performed by a trained and
qualified Volvo technician.
See also:
Brake pad inspection
On vehicles equipped with a jack*, the condition
of the brake pads can be checked by raising
the vehicle (see page 306 for information
about using the jack and removing a wheel)
and performing ...
INFO—displaying additional information
In certain cases, more information may be available (about a radio station, song,
artist, etc.) than is currently displayed on the screen. Press the INFO button to
display all of the available i ...
Replacing the daytime running lightbulb (models with Active BendingLights only)
1. Remove the rubber cover over the bulb by
pulling it off.
2. Turn the bulb holder counterclockwise and
pull it out of the headlight housing.
3. Remove the connector from the bulb unit
by pres ...
