See also:

Operation
Controls and display 1 Resume previous settings, increase speed (each additional press increases speed by 1 mph (approximately 2 km/h). 2 Standby mode on/off 3 Set time interval 4 Put in activ ...

Replacing bulbs
When replacing bulbs, keep the following points in mind: • Never touch the glass of bulbs with your fingers. Grease and oils from your fingers vaporize in the heat and will leave a deposit on t ...

Driver Alert Control (DAC)– introduction
This function is intended to alert the driver if his/her driving becomes erratic, such as if the driver is distracted or fatigued. NOTE The camera has certain limitations, see page 159. A c ...