Tilt position
Tilt position, raised at the rear edge
1 Open (raise the rear edge of the front glass section) by pressing the rear edge of the control upward.
2 Close by pulling the rear edge of the control downward and holding it until the laminated panoramic roof has closed completely.
If the sun shade is completely closed, it will open approximately 2 inches (5 cm) when the laminated panoramic roof is opened to the tilt position.
See also:
Ignition modes and electrical current to RSE
RSE can be activated with the ignition in
modes I or II (and when the engine is running).
See page 82 for detailed information about the
various ignition modes. If a film is being played,
it wi ...
Shiftlock
When your vehicle is parked, the gear selector
is locked in the P (Park) position. To release the
selector from this position, the ignition must be
in mode II (see page 82) or the engine must
...
Brake lights and taillights
The brake lights and taillights are replaced from
inside the cargo area.
NOTE
Before starting to replace a bulb, see
page 322.
1. Open the panel.
2. Remove the bulb holder by turning it coun ...