Ignition mode I
NOTE
To access ignition modes I or II without starting
the engine, the brake pedal must not be
depressed.
- With the remote key fully pressed into the ignition slot, press START/STOP ENGINE briefly.
See also:
Components in the SIPS airbag system
This SIPS airbag system consists of a gas generator, the side airbag modules
built into the outboard sides of both front seat backrests, and electronic sensors/wiring.
WARNING
The SIPS air ...
High beam flash
Move the lever toward the steering wheel to
position 1. The high beams come on until the
lever is released. ...
Dialing a number
The system understands the digits zero to nine. These numbers can be spoken individually,
in groups of several digits at a time, or the entire number can be given at once.
Numbers above nine will ...