Switching off the rear screens

Both of rear screens can be switched off from
the front center control panel. This function can
be activated under RSE settings
Display
off as explained in points 2-4 in the section
"Selecting a source for the rear screens
from the front center control panel" on page
248.
Press one of the remote control's number keys (0 - 9) to switch the screens on again. The screens will also be switched on when the ignition is switched on.
See also:
High/low beam headlights
Continuous high beams
1. Set the ignition to mode II.
2. With the light switch in position 0 or
, pull the turn signal lever toward
the
steering wheel to position 2 to toggle
between high an ...
What is an Onboard Diagnostic System (OBD II)?
OBD II is part of your vehicle's computerized
engine management system. It stores diagnostic
information about your vehicle's emission
controls. It can light the Check Engine light
(MIL) if it ...
Fault tracing and actions
If the message Windscreen Sensors
blocked is displayed, this means that the camera
is obscured and cannot detect pedestrians,
vehicles or road marker lines in front of the
vehicle.
This, in t ...
