Keyless drive information messages

Keyless drive information messages  - Keyless drive (models with Personal Car 
Communicator only) - Keyless drive - Locks and alarm - Volvo XC60 Owners Manual - Volvo XC60

If all of the PCCs are removed from the vehicle while the engine is running or if the ignition is in mode II (see page 82) and all of the doors are closed, a message will appear in the instrument panel display and an audible signal will sound.

When at least one PCC has been returned to the car, the message will be erased in the display and the audible signal will stop when:
• A door has been opened and closed
• The PCC has been inserted in the ignition slot
• The READ button (see page 131 for the location of this button) has been pressed.

CAUTION • Keyless drive remote keys should never be left in the vehicle. In the event of a break-in, a remote found in the vehicle could make it possible to start the engine.
• Electromagnetic fields or metal obstructions can interfere with the keyless drive system. Avoid placing the remote key near cellular phones, metallic objects or e.g., in a metal briefcase.

USA – FCC ID:KR55WK48952, KR55WK48964

NOTE

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept interference received, including interference that may cause undesired operation.

CAUTION

Changes or modifications not expressly approved by the manufacturer could void the user's authority to operate the equipment.

Siemens VDO

5WK48891

Tested To Comply With FCC Standards

For Automobile Use

Canada – IC:267T-5WK48952, 267T-5WK48964, 267T-5WK48891

NOTE

This device complies with RSS -210 of Industry Canada. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept interference received, including interference that may cause undesired operation.

CAUTION

Changes or modifications not expressly approved by the manufacturer could void the user's authority to operate the equipment.

    See also:

    Rear fog light
    The rear fog light (located on the driver's side of the vehicle) can be reached from behind the bumper 1. Remove the bulb holder by turning it counterclockwise. 2. Remove the burned out bulb ...

    Low beam, Halogen
    1. Remove the headlight housing from the vehicle (see page 322). 2. Remove the cover over the bulbs (see page 323). 3. Unplug the connector from the bulb. 4. Remove the bulb by pressing the h ...

    Operation and function
    LDW can be switched on or off by pressing the button on the center console. A light in the button illuminates when the function is on. The trip computer display shows Lane Depart Warn Standby < ...