Rear fog light
1. Switch off the ignition.
2. Carefully insert a small screwdriver (see
illustration above).
3. Pry out the lamp housing.
4. Turn the bulb holder counterclockwise and
remove it.
5. Turn the bulb counterclockwise and
remove it.
6. Insert a new bulb and press the lamp housing
back into place.
See also:
License plate lights
1. Switch off the ignition.
2. Loosen the screws with a Torx screwdriver.
3. Turn the bulb holder counterclockwise and
pull it out.
4. Pull out the defective bulb and insert a new
one.
5. Rein ...
Tire ratings
Speed ratings
The speed ratings in the table translate as follow:
Load ratings
See page 292 for an explanation of the load
rating on the sidewall of the tire. ...
Filling washer fluid
Location of the washer fluid reservoir
The windshield and headlight washers share a common reservoir.
The washer fluid reservoir is located on the driver's side of the engine compartment.
Du ...