Replacing high/low beams/turn signal/parking light bulbs

Volvo XC90 / Volvo XC90 Owners Manual / Maintenance and servicing / Replacing bulbs / Replacing high/low beams/turn signal/parking light bulbs

Replacing high/low beams/turn signal/parking light bulbs - Replacing bulbs - Maintenance and servicing - Volvo XC90 Owners Manual - Volvo XC90

WARNING
• The engine should not be running when changing bulbs.
• If the engine has been running just prior to replacing bulbs in the headlight housing, please keep in mind that components in the engine compartment will be hot.

WARNING
Active Bending Lights - due to the high voltage used by these headlights, these bulbs should only be replaced by a trained and qualified Volvo service technician.

The entire lamp housing must be lifted out

The entire lamp housing must be lifted out when replacing these bulbs.

To lift out the lamp housing:

1. Switch off the ignition.
2. Open the hood.
3. Pull up the retaining pins (see the illustration).
4. Lift out the lamp housing.

    See also:

    Cruise control
    Steering wheel-mounted controls and display 1 - Standby mode 2 - Resume set speed 3 - Deactivating 4 - Activate/set speed 5 - Set speed indicator (parentheses indicate standby mode) Engaging ...

    Towing vehicles with front wheel drive/ All Wheel Drive
    Volvo recommends the use of flat bed equipment. If wheel lift equipment must be used, please use extreme caution to help avoid damage to the vehicle. In this case, the vehicle should be towed w ...

    Cleaning the sensors
    Location of the front sensors Location of the rear sensors The sensors must be cleaned regularly to ensure that they work properly. Clean them with water and a suitable car washing detergent. ...