Service position
Wiper blades in service position
The wiper blades must be in the vertical (service) position for replacement, washing or to lift them away from the windshield when e.g., removing ice or snow. To put them in this position:
1. While sitting in the driver's seat, close the driver's door.
2. Insert the remote key in the ignition slot
3. Put the ignition in mode II (see page 86).
4. With the remote key in the ignition slot1, put the ignition in mode 0.
5. Move the right steering wheel lever up and hold it for at least 1 second. The wipers will then move to the vertical (service) position on the windshield.
The wipers can be returned to the normal position by briefly switching on the ignition (or by starting the engine).
See also:
Changing the set speed
After a speed has been set, it can be increased
or decreased by using the or
buttons.
Each time one of these buttons is pressed, the
vehicle's speed changes by 5 mph
(approximately 8 km/h). ...
Child safety locks
Child safety locks in the rear doors
Manual child safety locks – rear doors/
tailgate
The controls are located on the rear door jambs
and at the lower edge of the tailgate. Use a key
or small s ...
Seat belt pretensioners
All seat belts are equipped with pretensioners that reduce slack in the belts.
These pretensioners are triggered in situations where the front or side impact airbags
deploy, and in certain impacts ...