Detachable trailer hitch (accessory)
A - Ball holder
B - Locking bolt
C - Cotter pin
D - Hitch assembly
E
- Safety wire attachment
Installing the ball holder
1. If necessary, remove the cotter pin from the locking bolt and slide the locking bolt out of the hitch assembly.
2. Slide the ball holder into the hitch assembly.
3. Align the hole in the ball holder with the one in the hitch assembly.
4. Slide the locking bolt through the hitch assembly/ball holder.
5. Insert the cotter pin in the hole at the end of the locking bolt.
Removing the ball holder
1. Remove the cotter pin from the locking bolt and slide the locking bolt out of the ball holder/hitch assembly.
2. Pull the ball holder out of the hitch assembly.
NOTE
A cover for the hitch assembly is also included in the kit.
See also:
Recalibrating TPMS (Canadian models only)
In certain cases, it may be necessary to recalibrate
TPMS to conform to Volvo's recommended
tire inflation pressures (see the inflation pressure table on page 291), for
example,
if higher infl ...
Cold weather precautions
If you wish to check your vehicle before the approach of cold weather, the following
advice is worth noting:
Make sure that the engine coolant contains 50 percent antifreeze. Any other
mixtur ...
Conserving electrical current
Keep the following in mind to help minimize
battery drain:
• When the engine is not running, avoid
using ignition mode II. Many electrical systems
(the audio system, the optional navigation
s ...