Selecting a channel
There are three ways of tuning in a channel:
- Using the left and right arrow keys to go to the next channel. Skipped channels (see page 220) will be excluded.
- By turning the TUNE control and selecting a channel from the list
- Through direct channel entry.
NOTE
- The numbers of skipped or locked channels will not be displayed.
- If a channel is locked, the access code must be entered before the channel can be selected. See "Unlocking a channel" on page 220.
See also:
Function check
All indicator and warning symbols light up in ignition mode II or when the engine
is started. When the engine has started, all the symbols should go out except the
parking brake symsymbol, which o ...
Changing the set speed
After a speed has been set, it can be increased
or decreased by using the or
buttons.
Each time one of these buttons is pressed, the
vehicle's speed changes by 5 mph
(approximately 8 km/h). ...
Oil pressure warning light
If the light comes on while
driving,
stop the vehicle and then
stop the engine immediately and
check the engine oil level. If the light stays on after
restart, have the vehicle towed to the nea ...