Shiftlock override


If the vehicle cannot be driven, for example because of a dead battery, the gear selector must be moved from the P position before the vehicle can be moved3.
1 - Lift away the rubber mat on the floor of the storage compartment behind the center console to expose the small opening for overriding the shiftlock system.
2 - Insert the key blade into the opening. Press the key blade down as far as possible and keep it held down. Move the gear selector from the P position. For information on the key blade, see page 59.
See also:
Front seats
1 - Lumbar support: turn the control for firmer or softer lumbar support.
2 - Front-rear adjustment: lift the bar and move the seat to the position of
your choice.
3 - Raise/lower front edge of ...
Pause
When the audio system volume is turned off
completely, the player will pause and will
resume playing when the volume is turned up
again. ...
High/low beam headlights
Continuous high beams
1. Set the ignition to mode II.
2. With the light switch in position 0 or
, pull the turn signal lever toward
the steering wheel to position 2 to toggle between high and low ...
