Keyless drive information messages
If all of the PCCs are removed from the vehicle while the engine is running or if the ignition is in mode II (see page 86) and all of the doors are closed, a message will appear in the instrument panel display and an audible signal will sound.
When at least one PCC has been returned to the car, the message will be erased in the display and the audible signal will stop when:
- A door has been opened and closed
- The PCC has been inserted in the ignition slot
- The READ button (see page 131 for the location of this button) has been pressed.
CAUTION
- Keyless drive remote keys should never be left in the vehicle. In the event of a break-in, a remote found in the vehicle could make it possible to start the engine.
- Electromagnetic fields or metal obstructions can interfere with the keyless drive system. Avoid placing the remote key near cellular phones, metallic objects or e.g., in a metal briefcase.
USA – FCC ID:KR55WK48952, KR55WK48964
NOTE
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept interference received, including interference that may cause undesired operation.
CAUTION
Changes or modifications not expressly approved by the manufacturer could void the user's authority to operate the equipment.
Siemens VDO
5WK48891
Tested To Comply With FCC Standards
For Automobile Use
Canada – IC:267T-5WK48952, 267T-5WK48964, 267T-5WK48891
NOTE
This device complies with RSS -210 of Industry Canada. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept interference received, including interference that may cause undesired operation.
CAUTION
Changes or modifications not expressly approved by the manufacturer could void the user's authority to operate the equipment.
See also:
Marker lines
1 - Marker line for a 1-foot (30-centimeter) zone behind the vehicle 2 - Marker
line for the clear back-up zone 3 - "Wheel tracks"
The solid line (1) indicates a zone within 1 ft (30 ...
Power moonroof*
Introduction
The moonroof controls are located in the ceiling console near the rearview mirror.
The moonroof can be opened vertically and horizontally. The vehicle's ignition must
be in mode ...
Changing a wheel
1. Apply the parking brake and put the gear selector in P.
2. Take out the jack*, lug wrench*, the towing eyelet and the wheel cover removal
tool* stowed under the floor of the trunk.
3. Remove th ...