Rear seats
The seat belt reminder in the rear seat has two additional functions:
- It provides information about which seat belts are fastened in the rear seat. A message will appear in the information display when a belt is being used. This message will disappear after approximately 6 seconds or can be erased by pressing the READ button on the left steering wheel lever.
- It also provides a reminder if one of the occupants of the rear seat has unbuckled his/her seat belt while the vehicle is in motion. A visual and audible signal will be given. These signals will stop when the seat belt has been re-buckled or can be stopped by pressing the READ button.
- The message Unbelted in rear seat will appear in the information display if one of the rear doors has been opened.
The message in the information display can always be accessed, even if it has been erased, by pressing the READ button to display stored messages.
See also:
Gate Operator/Canadian Programming
Canadian radio-frequency laws require transmitter
signals to “time-out” (or quit) after several
seconds of transmission – which may not
be long enough for HomeLink to pick up the
signal during ...
Storing wheels and tires
When storing complete wheels (tires mounted
on rims), they should be suspended off the
floor or placed on their sides on the floor.
Tires not mounted on rims should be stored on
their sides or ...
Using HDC
HDC allows the car to roll forward at a maximum
speed of 6 mph (10 km/h), and 4 mph
(7 km/h) in reverse. However, the accelerator
pedal can be used to select any speed that is
possible in firs ...