Removing the cover to access the bulbs
NOTE
Before starting to replace a bulb, see
page 322.
1. Open the retaining clamps by pressing them to the sides.
2. Pull the cover straight out.
Reinstall the cover in the reverse order.
See also:
Immobilizer (start inhibitor)
Each of the keys supplied with your vehicle
contains a coded transponder. The code in the
key is transmitted to an antenna in the ignition
slot where it is compared to the code stored in
the s ...
Replacing the battery
1. Switch off the ignition.
2. Wait at least 5 minutes after switching
off the ignition before disconnecting the
battery so that all information in the vehicle's
electrical system can be stored ...
Location of tail light bulbs
1 Parking light
2 Turn signal
3 Back-up light
4 Parking light
5 Brake light
NOTE
If the message indicating a burned out bulb
remains in the information display after a
bulb has been replaced ...