Messages

Messages  - Parking brake - Your driving environment - Volvo XC60 Owners Manual - Volvo XC60

Park brake not fully released – A fault is preventing

parking αεροδρομιο βενιζελοσ

Park brake not fully released – A fault is preventing the parking brake from being released.

Try to apply the parking brake and release it several times. If the problem persists, contact an authorized Volvo workshop. If you drive off with this error message showing, a warning signal sounds.

Parking brake not applied – A fault is preventing the parking brake from being applied.

Try to apply the parking brake and release it several times. If the problem persists, contact an authorized Volvo workshop. If you drive off with this error message showing, a warning signal sounds.

Parking brake Service required – A fault has occurred. Try to apply and release. Contact a Volvo workshop if the fault remains.

WARNING
If the vehicle must be parked before the fault has been corrected, always put the gear selector in P and turn the wheels so that they point away from the curb if the vehicle is pointing uphill or toward the curb if it is pointing downhill.

    See also:

    Hood and engine compartment
    Turn the handle located under the left side of the dash approximately 20-25 degrees clockwise to release the hood lock. Lift the hood slightly. Press the release control (located under the r ...

    Switching to another device
    It is possible to switch among paired Bluetooth® devices that are in the vehicle. To do so: 1. Press MEDIA several times until Bluetooth is displayed, release the button and wait for several ...

    Location of taillight bulbs
    Brake lights (LEDs) Brake light Backup light Turn signals Rear fog light (driver’s side only) NOTE If an error message remains in the display after a faulty bulb has been replace ...