Erasing HomeLink Buttons
To erase programming from the three Home- Link buttons (individual buttons cannot be erased but can be “reprogrammed” as outlined below), follow the step noted:
1. Press and hold the two outer HomeLink buttons until the indicator light begins to flash-after 10 seconds.
2. Release both buttons. Do not hold for longer that 20 seconds.
HomeLink is now in the train (or learning) mode and can be programmed at any time beginning with “Programming” - step 1.
See also:
Turn signals
1. Remove the headlight housing from the vehicle (see page 306).
2. Remove the cover by pulling it straight out.
3. Pull the holder to access the bulb.
4. Press in the bulb and turn it to remove ...
Shortcut
The menu alternatives are numbered and can
be accessed directly by pressing the respective
keys on the numbered keypad on the left
side of the audio panel. ...
Jump starting
Connecting the jumper cables
Follow these instructions to jump start your vehicle's dead battery or to jump
start another vehicle's dead battery using your vehicle. If the 12-volt auxilia ...