High/low beam headlights

Continuous high beams
1. Set the ignition to mode II.
2. With the light switch in position 0 or
, pull the turn signal lever toward
the
steering wheel to position 2 to toggle
between high and low beams (this also
applies on models equipped with the
optional Active Bending Lights).
> The symbol
illuminates in the
instrument panel to indicate that the
high beams are on.
See also:
Brake pad inspection
On vehicles equipped with a jack, the condition
of the brake pads can be checked by raising
the vehicle (see page 190 for information
about using the jack and removing a wheel)
and performing a vi ...
Severe strain on the brake system
The brakes will be subject to severe strain
when driving in mountains or hilly areas, or
when towing a trailer. Vehicle speed is usually
slower, which means that the cooling of the
brakes is l ...
Engine and cooling system
Under special conditions, for example when driving in hilly terrain, extreme
heat or with heavy loads, there is a risk that the engine and cooling system will
overheat. Proceed as follows to avoid ...
