Replacing parking light/side markerlight bulbs
1. Turn the lamp holder approximately 1/4
turn counterclockwise and pull it out of the
headlight housing.
2. Pull the bulb straight out.
3. Align the guide lugs on the side of the base
of the new bulb in the grooves in the holder
and press it into place.
4. Press the lamp holder into the place in the
headlight housing and turn it approximately
1/4 turn clockwise.
See also:
Compliance
FCC/IC common sentence
This device complies with Part 15 of FCC Rules and RSS-Gen of IC Rules. Operation
is subject to the following two conditions: (1) this device may not cause interference,
an ...
Folding the backrests in the front seat
The front passenger seat backrest can be
folded to a horizontal position to make room for
a long load. Fold the backrest as follows:
1. Move the seat as far back as possible.
2. Adjust the backr ...
Sensors
The sunlight sensor on the dashboard and passenger
compartment temperature sensor in
the ECC control panel should not be covered
in any way as this could cause incorrect information
to be sent to ...