Checking settings
The current Collision Warning settings can be checked by pressing MY CAR on the center console control panel and going to Settings Car settings Driver support systems Collision Warning.
See also:
Fault tracing and actions
If the message Radar blocked See manual is
displayed, this means that the radar signals
from the sensor have been obstructed and that
a vehicle ahead cannot be detected.
This, in turn, means th ...
Tire sealing system–temporarilyrepairing a flat tire
Temporarily repairing a flat tire is done in two
stages:
• Stage 1: The hole is sealed by pumping
sealing compound into the tire. The car is
then driven a short distance to distribute
the sea ...
Introduction
Normally, when the accelerator pedal is
released while driving down hills, the vehicle's
speed slows as the engine runs at lower rpm
(the normal engine braking effect). However, if
the downhil ...