Function
Location of the laser sensor in the windshield2
City Safety™ monitors traffic ahead of you using a laser sensor mounted in the upper section of the windshield. If a collision is imminent, City Safety™ will automatically apply the brakes, which may feel like hard braking.
If the difference in speed between your vehicle and the vehicle ahead is more than approximately 9 mph (15 km/h), City Safety™ alone cannot prevent a collision from taking place.
The driver must apply the brakes to help avoid a collision or reduce its effect.
When the function activates and applies the brakes, a message will appear in the information display to indicate that the system is/has been active.
NOTE
- When City Safety™ applies the brakes, the brake lights will illuminate.
- In cases where City Safety™ has stopped the vehicle, the system will then release the brakes. The driver must apply the brakes to keep the vehicle at a standstill.
See also:
Repairing stone chips
1. Place a strip of masking tape over the damaged surface. Pull the tape off
so that any loose flakes of paint adhere to it.
2. Thoroughly mix the primer and apply it with a small brush.
3. When ...
Locks
The alarm indicator light on the dashboard will stop flashing to indicate that
the alarm is not monitoring the entire vehicle. The accessory movement and inclination
sensors will be automatically ...
Emergency Brake Assistance
EBA is designed to provide full brake effect
immediately in the event of sudden, hard braking.
The system is activated by the speed with
which the brake pedal is depressed.
When the EBA system i ...