Removal
Switch off the ignition, remove the remote key from the ignition slot and wait at least 5 minutes before disconnecting the battery so that all information in the vehicle's electrical system can be stored in the control modules.
1 Open the clips on the front cover and remove the cover.
2 Release the rubber molding so that the rear cover is free.
3 Remove the rear cover by pulling it away.
4 1 Detach the black negative cable.
2 Detach the red positive cable
3 Detach the ventilation hose from the battery
4 Loosen the screw holding the battery clamp.
5Move the battery to the side and lift it up.
WARNING
PROPOSITION 65 WARNING!
Battery posts, terminals, and related accessories
contain lead and lead compounds,
chemicals known to the state of California
to cause cancer and reproductive harm.
Wash hands after handling.
See also:
Contact shortcuts
A quick way of searching the phone book for
contacts in normal view is to turn TUNE clockwise
to access the phone book and then counter-
clockwise to select a contact from the list.
Press OK/ME ...
Introduction
Adaptive Cruise Control (ACC) is an optional system designed to assist the driver
by maintaining a set speed or a set time interval to the vehicle ahead. It is primarily
intended for use on long s ...
Handling
• Check that the battery cables are correctly
connected and tightened.
• Never disconnect the battery when the
engine is running (for example, when
replacing the battery).
• If the battery is ...