Reinserting the headlight housing

Reinserting the headlight housing - Headlight housing - Replacing bulbs - Maintenance and specifications - Volvo XC60 Owners Manual - Volvo XC60

When reinserting the housing, be sure that the

When reinserting the housing, be sure that the long locking pin (to the left in the illustration) is securely in place in both of its retaining clamps.

1. Plug in the connector until it clicks into place.

2. Reinstall the headlight housing and locking pins. Check that they are correctly inserted. The headlight housing must be properly inserted and secured in place before the lighting is switched on or the remote key is inserted into the ignition slot.

3. Check that the lights function properly.

The headlight wiring must be connected and the housing must be securely in place before the ignition is switched on.

    See also:

    Unbuckling the seat belt
    To remove the seat belt, press the red section on the seat belt receptacle. Before exiting the vehicle, check that the seat belt retracts fully after being unbuckled. If necessary, guide the b ...

    Removing the ball holder
    1. Remove the cotter pin from the locking bolt and slide the locking bolt out of the ball holder/hitch assembly. 2. Pull the ball holder out of the hitch assembly. NOTE A cover for the hitch as ...

    Search paths
    Throughout this manual, search paths to the menu system functions are listed as shown in the following example: Audio settings Equalizer, if the following steps have been taken first: 1. Pres ...