Deactivation

Move the gear selector from R to another position.
There is a slight delay in the PAC system, which means that the view from behind the vehicle will remain on the screen for approximately 15 seconds after the gear selector has been moved from the R position or until the vehicle reaches a forward speed of 6 mph (10 km/h). The screen will then revert to the mode that it was in before R was selected and will, for example, display navigation system information.
NOTE
If any button on the center console control
panel is pressed, the camera image will disappear
from the display. Pressing CAM will
return the camera image to the display.
See also:
Inserting and removing the remote key
Ignition slot with remote key and START/STOP ENGINE button.
Inserting the remote key1
Holding the end of the remote key with the base of the key blade, insert the
remote key into the ignition sl ...
Repairing stone chips
1. Place a strip of masking tape over the damaged
surface. Pull the tape off so that any
loose flakes of paint adhere to it.
2. Thoroughly mix the primer and apply it with
a small brush.
3. ...
Lowering the spare wheel
The spare wheel is located under the floor of
the rear cargo compartment. It can be lowered
using the crank (see previous page for location).
WARNING
When raising or lowering the spare wheel,
ple ...
