Operating
Operating the power windows
1 Manual up/down
2 Auto up/down.
All power windows can be operated using the control panel in the driver's door. The control panels in the other doors only operate the window in the respective doors.
For the power windows to function, the ignition must be in at least mode I. When the vehicle has been running, the power windows can be operated for several minutes after the remote key has been removed from the ignition slot, or until a door has been opened.
NOTE
• Movement of the windows will stop if
they are obstructed in any way.
• To reduce buffeting wind noise if the rear windows are opened, also open the front windows slightly.
Manual up/down
- Move one of the controls up/down slightly.
> The power windows move up/down as long as the control is held in position.
Auto up/down
- Move one of the controls up/down as far as possible and release it.
> The window will open or close completely.
See also:
RSE menus
IntroductionSettings in the RSE menus can be made
from
the front center console control panel or by
using the remote control in the rear seat. A
source for one of the rear screens can be activ ...
Turn signals
1. Remove the headlight housing from the
vehicle (see page 322).
2. Remove the bulb holder by turning it counterclockwise
and pulling it out of the headlight
housing.
3. Pull out the holder ...
Guiding lines
The lines on the screen are projected as if they
were a path on the ground behind the vehicle
and are affected by the way in which the steering
wheel is turned. This enables the driver to
se ...