Handling, roadholding

Vehicle load, tire design and inflation pressure all affect vehicle handling. Therefore, check that the tires are inflated to the recommended pressure according to the vehicle load. See the "Tire pressure" section. Loads should be distributed so that capacity weight or maximum permissible axle loads are not exceeded.
See also:
Operation
Controls and display
1 Resume previous settings, increase speed (each additional press increases
speed by 1 mph (approximately 2 km/h).
2 Standby mode on/off
3 Set time interval
4 Put in activ ...
Putting ACC in standby mode
Before ACC can be used to regulate speed and/or the distance to a vehicle ahead,
it must first be put in standby mode.
To do so:
Press .
The symbol appears in the display
and parentheses (---) ...
Lowering the spare wheel
The spare wheel is located under the floor of
the rear cargo compartment. It can be lowered
using the crank (see previous page for location).
WARNING
When raising or lowering the spare wheel,
ple ...
