Deactivation

Move the gear selector from R to another position. There is a slight delay in the PAC system, which means that the view from behind the vehicle will remain on the screen for approximately 15 seconds after the gear selector has been moved from the R position or until the vehicle reaches a forward speed of 6 mph (10 km/h). The screen will then revert to the mode that it was in before R was selected and will, for example, display navigation system information.
NOTE
If any button on the center console control panel is pressed, the camera image will disappear from the display. Pressing CAM will return the camera image to the display.
See also:
Using voice commands
The driver initiates a voice command dialogue
by pressing the voice control button (see the
illustration on page 241).
When a dialogue has been initiated, commonly
used commands will be shown i ...
Introduction
The Dynamic Stability and Traction Control system (DSTC) consists of a number
of functions designed help reduce wheel spin, counteract skidding, and to generally
help improve directional stability ...
Electrical system
General information
12 volt system with a voltage-regulated alternator. Single pole system in which
the chassis and engine block are used as conductors. The negative terminal is connected
to the ...
