Power moonroof*
Introduction
The moonroof controls are located in the ceiling console near the rearview mirror. The moonroof can be opened vertically and horizontally. The vehicle's ignition must be in mode I or II for the moonroof to be operated.
CAUTION
- Remove ice and snow before opening the moonroof.
- Do not operate the moonroof if it is frozen closed.
- Never place heavy objects on the moonroof.
Sliding moonroof
Sliding moonroof, forward/rearward
1 - Opening, automatic
2 - Opening, manual
3 - Closing, manual
4 - Closing, automatic
Automatic opening
Pull the switch as far back as possible (to the position for automatic opening) and release it to automatically fully slide open the moonroof.
Manual opening
Pull the switch back to the first stop (the position for manual opening) and hold it until the moonroof has opened to the position of your choice.
Manual closing
Push the switch forward to the first stop (the position for manual closing) and hold it until the moonroof has closed to the position of your choice, or has closed completely.
Automatic closing
Push the switch as far forward as possible (the position for automatic closing) and release it to automatically close the moonroof.
WARNING
- During manual closing, if the moonroof is obstructed, immediately open it again.
- Never open or close the moonroof if it is obstructed in any way.
- Never allow a child to operate the moonroof.
- Never leave a child alone in a vehicle.
- Never extend any object or body part though the open moonroof, even if the vehicle's ignition is completely switched off.
Tilt position
Tilt position, raised at the rear edge
1 - Open by pressing the rear edge of the control upward.
2 - Close by pulling the rear edge of the control downward and hold it until the moonroof has closed completely.
Visor
The moonroof features a sliding visor. The visor slides open automatically when the moonroof is opened, and must be closed manually.
See also:
Low beam, Halogen
1. Remove the headlight housing from the vehicle (see page 306).
2. Remove the cover over the bulbs (see page 308).
3. Unplug the connector from the bulb.
4. Remove the bulb by pulling it straigh ...
Main CD Audio menu
Disc menu
Random
Scan
Audio settings ...
Audible signals from the park assistsystem
The Park Assist system uses an intermittent
tone that pulses faster as you come close to an
object, and becomes constant when you are
within approximately 1 ft (30 cm) of an object
in front of or ...