Removing the headlight housing


1. Switch off the ignition by briefly pressing the START/STOP ENGINE button.
2. Remove the remote key from the ignition slot1.
3. (Upper illustration under "Headlight housing").
1 Withdraw the headlight housing's locking pins.
2 Pull the headlight housing straight out.
CAUTION When disconnecting the connector, pull on the connector itself and not on the wiring.
4. (Lower illustration under "Headlight housing").
1 Unplug the wiring connector by holding down the clip with your thumb.
2 Pull out the connector with the other hand.
5. Lift out the housing and place it on a soft surface to avoid scratching the lens.
6. Replace the defective bulb(s).
See also:
Anti-lock braking system (ABS)
The Anti-lock Braking System (ABS) helps to
improve vehicle control (stopping and steering)
during severe braking conditions by limiting
brake lockup. When the system "senses"
impend ...
Navigating in the menus
Infotainment settings are made via the system's
menus. Press one of the mode buttons
(RADIO, MEDIA, or TEL—see the illustration
on page 206) to select it and access its specific
menus. When a ...
Marker lines
1 - Marker line for a 1-foot (30-centimeter) zone behind the vehicle 2 - Marker
line for the clear back-up zone 3 - "Wheel tracks"
The solid line (1) indicates a zone within 1 ft (30 ...
