Checking and adding oil

Checking and adding oil  - Engine oil - Maintenance and specifications - Volvo XC60 Owners Manual - Volvo XC60

Location of the filler cap and dipstick
Location of the filler cap and dipstick

Volvo recommends Castrol oil products
Volvo recommends Castrol oil products

NOTE
Before checking the oil:
• The car should be parked on a level surface.
• If the engine is warm, wait for at least 10 – 15 minutes after the engine has been switched off.

The oil level must be between the MIN and MAX marks on the dipstick
The oil level must be between the MIN and MAX marks on the dipstick

Checking the oil

1. Pull out the dipstick and wipe it with a lintfree rag.

2. Reinsert the dipstick, pull it out, and check the oil level. The level must be between the MIN and MAX marks.

3. Add oil if necessary. If the level is close to the MIN mark, add approximately 0.5 US quarts (0.5 liters) of oil.

4. Recheck the level and add more oil if necessary until the level is near the MAX mark.

WARNING
Do not allow oil to spill onto or come into contact with hot exhaust pipe surfaces.

NOTE
Synthetic oil is not used when the oil is changed at the normal maintenance intervals except at owner request and at additional charge. Please consult your Volvo retailer.

    See also:

    Repairing stone chips
    1. Place a strip of masking tape over the damaged surface. Pull the tape off so that any loose flakes of paint adhere to it. 2. Thoroughly mix the primer and apply it with a small brush. 3. When ...

    Minor scratches on the surface
    If the stone chip has not penetrated down to the metal and an undamaged layer of paint remains, the touch-up paint can be applied as soon as the spot has been cleaned. ...

    Turn signal indicator – trailer (certainmodels)
    If you are towing a trailer, this light will flash simultaneously with the turn signals on the trailer. If the light does not flash when signaling, neither the trailer's turn signals nor the ve ...