Fault tracing and actions
If the message Radar blocked See manual is displayed, this means that the radar signals from the sensor have been obstructed and that a vehicle ahead cannot be detected.
This, in turn, means that the functions of the ACC, Distance Alert, and Collision Warning System with Auto-brake and Pedestrian Detection will not function.
The table lists possible causes for this message being displayed, and suitable actions.
Cause | Action |
The surface of the radar in the grille is dirty or obstructed in some way. | Clean the radar surface, or remove the object causing the obstruction. |
Heavy rain or snow is interfering with the radar signals. | No action possible. Heavy precipitation may affect the function of the radar. |
Swirling water or snow from the surface of the road may interfere with the radar signals. | No action possible. A very wet or snow-covered road surface may affect the function of the radar. |
The surface of the radar is clean but the message remains in the display. | Wait a short time. It may take several minutes for the radar to detect that it is no longer obstructed. |
See also:
Automatic re-arming
If the doors are unlocked, the locks will automatically
reengage (re-lock) and the alarm will
re-arm after 2 minutes unless a door or the tailgate
has been opened. ...
Safety & Reliability
The C70 scores the highest rating, Good, in the Insurance Institute for
Highway Safety's frontal offset and side-impact crash tests, as well as for
rear-crash protection.
In addition to the requ ...
Gate Operator/Canadian Programming
Canadian radio-frequency laws require transmitter
signals to “time-out” (or quit) after several
seconds of transmission – which may not
be long enough for HomeLink to pick up the
signal during ...