Basic sound settings

Press SOUND to display the basic sound setting menu (Bass, Treble, etc). Continue pressing SOUND or OK/MENU to display the other setting alternatives.
Adjust the setting by turning TUNE and save the new setting by pressing OK/MENU. Continue pressing SOUND or OK/MENU to display:
- Surround:1 Can be set to On or Off. When switched on, the system will automatically
select settings for the best sound quality, which is normally DPLII and
will appear in the display. If
the recording was made using Dolby Digital technology, playback will be provided
with this setting and
will appear
in the display. If Surround is switched off, audio will be provided using 3
channel stereo. - Bass: Bass level.
- Treble: Treble level.
- Fader: Balance between the front and rear speakers.
- Balance: Balance between the right and left speakers.
See also:
License plate lighting
1. Remove the screws with a screwdriver.
2. Carefully detach the entire bulb housing and pull it out.
3. Replace the bulb.
4. Reinsert the entire bulb housing and tighten the screws. ...
Remote key not functioning
If the remote key is not functioning properly,
the alarm can be turned off and the vehicle can
be started as follows:
1. Open the driver's door with the key blade
(see page 61 for information o ...
Rain sensor
The rain sensor automatically regulates wiper
speed according to the amount of water on the
windshield. The sensitivity of the rain sensor
can be adjusted moving the thumb wheel up (the wipers w ...
