See also:

Tilt position
Tilt position, raised at the rear edge 1 Open (raise the rear edge of the front glass section) by pressing the rear edge of the control upward. 2 Close by pulling the rear edge of the control ...

Replacing the high beam bulb (halogenheadlights)
1. Remove the rubber cover by pulling it off. 2. Pull the connector from the lamp housing. 3. Loosen the bulb's retaining spring by first moving it to the right and then moving it out of the way ...

Operation
Chassis settings Use the buttons in the center console to change setting. The setting in use when the engine is switched off is activated the next time the engine is started. ...