Using HomeLink
To operate, simply press and release the programmed HomeLink button. Activation will now occur for the trained device (i.e., garage door opener, gate operator, security system, entry door lock, home/office lighting, etc.). For convenience, the hand-held transmitter of the device may also be used at any time. In the event that there are still programming difficulties or questions, contact HomeLink at: www.homelink.com.
See also:
Turning ACC off completely
From standby mode, press once.
From active mode, press twice.
The set speed and time interval are then cleared from the system's memory and
cannot be resumed by pressing . ...
Replacing fuses
There are relay/fuse boxes located in the
engine compartment, the passenger compartment,
and the cargo area.
If an electrical component fails to function, this
may be due to a blown fuse. The e ...
Introduction
Collision Warning with Full Auto-brake and Pedestrian Detection is designed to
assist the driver if there is a risk of a collision with a pedestrian, a vehicle
ahead that is at a standstill or one ...