Selecting a magnetic zone


Magnetic zones.
The earth is divided into 15 magnetic zones. The correct zone must be selected for the compass to work correctly.
1. Put the ignition in mode II.
2. Using a pen or similar object, press and hold the button on the rear side of mirror for at least 3 seconds. The number for the current area will be shown.
3. Press the button repeatedly until the number for the required geographic area (1 – 15) is shown.
4. The display will revert to showing the compass direction after several seconds.
See also:
High/low beam headlights
Continuous high beams
1. Set the ignition to mode II.
2. With the light switch in position 0 or
, pull the turn signal lever toward
the steering wheel to position 2 to toggle between high and low ...
Maintenance
Use a screw driver to open the caps or cover and a flashlight to inspect
the level.
If necessary, add distilled water. The level should never be above the indicator.
The fluid level should b ...
Folding the grid up/down
Grasp the lowering edge of the grid and pull it
rearward/upward, or push it downward/forward.
NOTE
If the steel grid is to be used with the
optional cargo area cover, the grid must be
folded d ...
