Disabling the remote control (front)
The IR transceiver for the front screen can be switched off, which means that the remote control cannot be used on the front screen.
This function can be activated under RSE
settings
Disable remote control (front) as
explained in points 2-4 in the section "Selecting
a source for the rear screens from the front
center control panel" on page 248.
See also:
Fault tracing and actions
If the message Radar blocked See manual is displayed, this means that the radar
signals from the sensor have been obstructed and that a vehicle ahead cannot be
detected.
This, in turn, means that ...
Start
Ignition switch with remote key inserted ( see page 82 for more information
on ignition modes)
WARNING
Before starting the engine:
• Fasten the seat belt.
• Check that the seat, steering wheel ...
Standby mode (temporary deactivation)
Press to temporarily deactivate
cruise control
(put it in standby mode). The set speed, for
example 55 mph, is then shown in parentheses.
The previously set speed and time interval are
resum ...