Introduction
The laminated panoramic roof is divided into two sections.
• The rear glass section is fixed in place and cannot be moved.
• The front glass section can be slid horizontally to the open or closed positions or its rear edge can be raised and lowered to allow ventilation.
All references in this section to opening or closing the panoramic roof pertain to the front glass section.
The laminated panoramic roof also has a sun shade made of perforated fabric that is located below the sections of glass. This shade can be opened or closed, for example when driving in bright sunlight.
Both the laminated panoramic roof and the sun shade are operated by the controls in the ceiling console, near the rear-view mirror. The vehicle's ignition must be in mode I or II before the laminated panoramic roof/sun shade can be operated.
CAUTION • Remove ice and snow before opening the laminated panoramic roof.
• Do not operate the laminated panoramic roof if it is frozen closed.
• Never place heavy objects on the laminated panoramic roof.
See also:
Manual operation
1. Opening the sun shade: Pull the control
back to the first stop (the manual open
position) and hold it until the sun shade has
opened to the position of your choice.
2. Opening the rear edge ...
Temperature control
The temperatures on the
driver and passenger sides
can be set separately. When
the vehicle is started, the
most recent setting is
resumed.
NOTE
Heating or cooling cannot be speeded up by ...
12-volt sockets
12-volt socket in the front tunnel console
The electrical sockets can be used for 12-volt accessories such as cell phone
chargers and coolers. For the socket to supply current, the ignition must ...