Erasing HomeLink Buttons
To erase programming from the three Home- Link buttons (individual buttons cannot be erased but can be “reprogrammed” as outlined below), follow the step noted:
1. Press and hold the two outer HomeLink
buttons until the indicator light begins to
flash-after 10 seconds.
2. Release both buttons. Do not hold for
longer that 20 seconds.
HomeLink is now in the train (or learning) mode and can be programmed at any time beginning with “Programming” - step 1.
See also:
Economical driving conserves natural resources
Better driving economy may be obtained by thinking ahead, avoiding rapid starts
and stops and adjusting the speed of your vehicle to immediate traffic conditions.
Observe the following rules:
B ...
Audio/video playback through the A/VAUX socket
1. Switch on one of the rear screens by pressing
its On/Off button.
2. Use the remote control's button
to
select a screen (L: left rear screen, F: front
screen, or R: right rear screen). Poi ...
Automatic connection
When the hands-free system is active and the
most recently connected cell phone is within
range, it is connected automatically. If this
phone is not within range, the hands-free system
will at ...