Unbuckling the seat belt
To remove the seat belt, press the red section on the seat belt receptacle. Before exiting the vehicle, check that the seat belt retracts fully after being unbuckled. If necessary, guide the belt back into the retractor slot.
See also:
Programming HomeLink
NOTE
Some vehicles may require the ignition
switch to be turned on or to the second
(“accessories”) position for programming
and/or operation of HomeLink. It is also recommended
that a new batter ...
Fault tracing and actions
If the message Windscreen Sensors
blocked is displayed, this means that the camera
is obscured and cannot detect pedestrians,
vehicles or road marker lines in front of the
vehicle.
This, in t ...
On and off
To switch Collision Warning on or off, press MY
CAR on the center console control panel and
go to Settings
Car settings
Driver
support systems
Collision Warning. If
Collision Warni ...