High beam, Halogen
1. Remove the headlight housing from the vehicle (see page 322).
2. Remove the cover over the bulbs (see page 323).
3. Remove the bulb by turning it counterclockwise and pulling it straight out.
4. Remove the connector from the bulb.
5. Press the new bulb into the socket and turn it clockwise to put it in place. It can only be secured in one position.
6. Reinsert the bulb holder into the headlight housing.
7. Put the cover back into position and reinstall the headlight housing.
See also:
Increasing or decreasing speed
Use + or – in the following ways to increase or
decrease the vehicle's speed:
1. Press and hold down + or – until the vehicle
reaches the desired speed.
2. Press + or – for approximately a hal ...
Air distribution
The incoming air is distributed from a number
of different vents in the passenger compartment.
Air distribution is fully automatic in AUTO
mode.
If desired, air distribution can be controlled ...
Skip options
This function is used to remove a channel from the list of available channels.
Skipping a channel
1. Press OK/MENU.
2. Scroll to the Advanced settings menu.
3. Press OK/MENU to enter the Skip opti ...