Applying the electric parking brake
Parking brake control
1. Press firmly on the brake pedal.
2. Push the control.
> The symbol in the instrument
panel flashes while the parking bake is
being applied, and glows steadily when
the parking brake has been fully applied.
3. Release the brake pedal and ensure that the vehicle is at a standstill.
4. When the vehicle is parked, the gear selector must be in position P.
NOTE
• In an emergency the parking brake can
be applied when the vehicle is moving
by holding in the control. Braking will be
interrupted when the accelerator pedal
is depressed or the control is released.
• An audible signal will sound during this
procedure if the vehicle is moving at
speeds above 6 mph (10 km/h).
See also:
Advanced
In this mode, body sway in curves is minimal
and steering response is very direct. Gear shifting
is done at high rpm in each gear for
dynamic and active driving. ...
Front park assist
The distance monitored in front of the vehicle is approximately 2.5 ft (0.8 m).
The audible signal comes from the audio system's front speakers.
It may not be possible to combine auxiliary he ...
Stage 2: Checking inflation pressure
1. Connect the tire sealing system as described
in stage 1.
2. Refer to the inflation pressure table in this
chapter for the correct inflation pressure. If
the tire needs to be inflated, start ...